Minitioune progress

After a long delay (other work, life getting in the way, general laziness etc) I ran some more tests on the Pibox. With the fans disconnected (actually, one disconnected itself!) and the case assembled I've been running the box to see how bad the temperatures get. With two of the three Pi cards operating, and all 3 powered up, pi-star, which is on top due to the DVMEGA hat settles at 60 degrees C, and the utility Pi which has a Discone attached settles at 50. So not actually bad. I think what I will do is go back to Plan C or whatever it was and run the fans via a transistor hanging off the GPIO port of one of the cards so the fan comes on if it is getting a bit steamy. For now, at least it means I can run pi-star 24/7 again, especially as I had to upgrade it by hand as it has missed a lot of the overnight updates. And it saves me having to run mains power into the loft.

The PiBox is almost completed. It's taken far too long due to all sorts of silly things like having to get fans because a dry run indicated the poor little boards were getting a bit hot, having to get bolts for the fans because I had none long enough, and having to get a connector for the 1-wire (actually 3 wires!) lead from the central heating sensors. So, there is is. Two fans on the left, 5V PSU bottom right, gigabit Ethernet switch above that, then the Pi's: top is the PiStar with the DVMega board which has coax to the rear panel and then a dummy load, middle is the ASD-B and central heating monitor Pi, and the bottom is a general purpose one with various bits on such as rtl_tcp. The lower two boards have USB-A sockets on the rear of the case for the two SDR sticks, one for the ADS-B antenna and one to attach to a Discone for general use. But there is an issue. I had originally intended this to sit in the shack but those fans are just too annoying. Not loud, but constant. I suspect the box will end up in the…

After ages I finally made a rain cover for the POTY and led cables into the garage. Big delay there because the garage was a tip. It still is a tip, but the mess has been rearranged so I have access to the air brick where the cables come in! It's nice that when they built the house in the 1930's they put an air brick right there knowing it would be needed for a satellite dish... The rain cover is made from a sheet of plastic that came out of a smashed LCD monitor. I bent it round a bit of 110mm drain pipe using a hot air gun. it didn't quite come out as intended but it's near enough. The front is from the same piece of plastic and is epoxy glued on - yes there is a gap where the glue was less gluey, I'll fix that later. Nylon threaded bar and nuts hold it in place. And it rained an hour after I made it so it does actually work. After all the messing about everything still works. There is a nice box on order to take the gubbins - ok, the Pluto, bias tee, Leo…