More QO100 progress...
After ages I finally made a rain cover for the POTY and led cables into the garage. Big delay there because the garage was a tip. It still is a tip, but the mess has been rearranged so I have access to the air brick where the cables come in!
It's nice that when they built the house in the 1930's they put an air brick right there knowing it would be needed for a satellite dish...
The rain cover is made from a sheet of plastic that came out of a smashed LCD monitor. I bent it round a bit of 110mm drain pipe using a hot air gun. it didn't quite come out as intended but it's near enough. The front is from the same piece of plastic and is epoxy glued on - yes there is a gap where the glue was less gluey, I'll fix that later. Nylon threaded bar and nuts hold it in place. And it rained an hour after I made it so it does actually work.
After all the messing about everything still works. There is a nice box on order to take the gubbins - ok, the Pluto, bias tee, Leo Bodnar GPSDO, power supplies, oh yes and the pre-amp and amp I have yet to build. I've got Ethernet into the garage and I have tested SDR Console over Ethernet to the Pluto and all seems to work ok.