Radio, railways, stuff...

M0RVB

Radiosonde monitoring

For some time now I had been running a radiosonde receiver based on one of the small Lilygo LoRa devices with a built-in display. It used wifi to connect to our LAN and thence off to its reporting platform https://sondehub.org/. Because it used an antenna in the loft it never did very much with regard to monitoring but it was a no-cost 'why not' type of thing. However, after some time now the display was dimming and it would often have issues if the wifi hub rebooted. So I really wanted a no-wifi solution and found one based on a Pi and an RTL-SDR dongle.The software and setup instructions I followed can be found here and worked semlessly. The setup creates its own web server, by default at port 5000. After a few days of nothing it finally recorded two hits overnight: Not too bad for a 70cm Big Wheel in the loft. Looking at the data, for the first entry which is the one approaching Liverpool data was received when it was at 11,500m altitude down to 9,521m at 403.4MHz. The second trace out to sea was on 405.1MHz and from 19,670M to 25,349m at the end. The traces are just the part of the whole that my receiver recorded but it is at least something. There is a lot of information at https://sondehub.org/ - the serial numbers for the two traces I received were X3113229 and X3112899 and the data for each plus who / what received it can be queried at sondehub.

Continue reading...
M0RVB

Moving things about

Since I got it the FTM510D has been mounted under the shelf above the monitors. While that was ok it meant the mic lead was always caught behind one of the monitors. Having tidied one bookshelf and moved things around moving the Portsdown left a space under one of the three screens. A space, I thought ideal for the FTM510D. But how to mount it neatly... A search for 3D prints for the radio resulted in mainly mobile solutions but I came across a comment on one aimed at an earlier model saying the dimensions should be the same. It seems the FTM150 has the same slidemount arrangement and dimensions. So, off to makerworld - https://makerworld.com/en/models/1181052-desktop-stand-for-ftm-150rasp-may-fit-others - and off to order more PLA because I had hardly any of any sort of black filament. Twenty eight and a bit hours later... my biggest and longest print to date. Anyway, it worked just fine. After trimming the bits the radio slots straight in. The model even has a slot to hang the mic, and it sits just right under the monitor. Four sticky feet to stop it sliding finished it off. Surprisingly all the cables were of sufficient length for the radio's new home. It has the usual power lead which is always plenty long enough, the antenna lead, audio lead and data lead to a TNC and then to the PC. All just right for a change. So now my three main radios are all in a row. It is also slightly easier to dust, a daily issue round here!

Continue reading...
M0RVB

Another 10MHz source

I seem to be gathering 10MHz stuff for some reason - but there is a plan. The latest toy to arrive is this BG7TBL 10MHz / 1pps GPSDO which arrived very quickly from China via Aliexpress. The primary role for this will be to feed the 10MHz distribution amplifier which in turn drives a few bits of equipment, plus give a 1pps signal to the rubidium oscillator (just for fun really!). My previous 10MHz source was the DX Patrol GPSDO which has been retired. Now I need to arrange all this frequency stuff somewhere rather than it being spread about. It's a pity this and the distribution amplifier need a maximum of 12.9V so the make shack PSUs are out and I set up a 12V SMPSU (which seems RF quiet fortunately) specifically for these plus the 12V for the Winterhill box.

Continue reading...