YouLoop (2)

M0RVB

Airspy and MacOS

Just recently I realised that amongst my kit I do not have a scanner other than the baby IC-R2. So I had a look to see what there is and they range from cheap but limited range ones that do not have a continuous coverage to expensive types that are just way over the top for my needs. My interest is limited to having something I can quickly switch on and listen to a few spot frequencies, including amateur radio ones and the local airport ATIS. I also have a bunch of various SDRs but none met the 'quickly switch on' requirement. Time to fiddle then. Other than the various Raspberry Pi systems the only always-on system I have is a Mac Mini. The other two desktops - Linux and Windows - only get turned on when I want to use the FT450D or TS2000X on digimodes or I need more screen real estate for something. So what can I do with the Mac? I already had CubicSDR loaded and I downloaded the Mac version of gqrx. As I use SDR# on Windows and after reading some blog posts I found and downloaded sdrpp. I already have the Airspy HF+ Discovery connected to the Windows box and a RTL-SDR V3 dongle. At this time my thoughts expanded to consider if I use an SDR then I want one with a very good range - so, the Airspy. Anyway, I mixed and matched the software and SDRs to see what fits the best. For CubicSDR and the RTL-SDR dongle I could not find a way to switch it to direct sampling mode so there was nothing below 24MHz. I probably missed a setting. This setup worked fine for VHF FM and airband. I could not get CubicSDR to see the Airspy. For GQRX and the RTL-SDR dongle again I could not find a way to switch to direct sampling. With the Airspy all went well except it was rather difficult to control down at VLF. That's probably just me. For SDRpp the RTL-SDR could be switched to direct sampling but at the end of the day it only works down to 500kHz. With the Airspy it is very like the Windows version which I find easy to use. I did note that when changing frequency a lot it can get confused - for example, I went from airband down to VLF and could not get to 60kHz time signal but it worked fine after restarting the software. A like for like comparison between the Airspy and SDR# on Windows and SDRpp on the Mac showed very similar results, the differences being to do with she speed of the waterfall and there are numerous settings to explore yet. So the Airspy is now connected full time to the Mac and the YouLoop. The real acid test will be to see if it holds up during the next SAQ broadcast later this year but it looks like it will. Above: Windows 10 +…

Continue reading...
M0RVB

SAQ 24/Dec/2024

SAQ was received fine here on the 24th December for their Christmas broadcast at 08:00. This was again using the Airspy HF+ Discover and YouLoop in the loft. I had a bit of time to fiddle with settings in SDR# this time, reducign the bandwidth to 100Hz and trying the HF AGC on and off - leaving it on produces better audio but really not much difference between on and off. The signal from SAQ was showing as -100dBFS vs -110dBFS background. Nothing at all received using vlfrx-tools via the UMC204HD + PA0RDT mini whip. That does show the same large peaks above 19kHz but not the one at about 16.5kHz (see above) nor that smaller peak seen at about 21kHz, so no surprise it did not see SAQ. But never mind, it's still useful. The Youtube recording of the event can be seen at https://www.youtube.com/watch?v=0CQZmW_vE00

Continue reading...