Server moves

Another Hamfest is over... 160 mile round trip for me (ok, plus a diversion where I followed the signs to a service station which were ok until the last junction and I ended up on another motorway!!) but not a bad trip. Except for the roadworks on the A1... Anyway, a 6/4/2/70cm collinear came home with me and it is now installed in the loft replacing the existing 2/70cm one. Same cable etc. I also finished off the boarding over one bedroom - surprisingly the one where the antenna is and no, that's not the reason for completing the boarding. Honest! It has, as one may expect very little gain at 6m and 4m but replaces the 4m ground plane that I had and was rather in the way. Plus I never had any form of vertical for 6m. I also managed to today the antennas up a bit. The 70cm big wheel is now no longer under the 2m big wheel and has its own place farther away. The 2m big wheel has moved so I can actually walk across the loft without needing to crawl under it. I also recently acquired 2m and a 70cm QFH antennas from…

I now have a Raspberry Pi set up on one of the four monitors in the shack. The original layout was two screens at the top on Linux, then bottom left on Windows and bottom right - central to where I sit on the Mac as the main screen. But that layout had two major issues... I use a program called Barrier to basically act as a KVM switch for the three systems with the Mac as server. That way the Mac mouse and keyboard controls any of the systems, although it can be awkward sometimes where Windows expects keys which Apple doesn't have. But Barrier does not understand dual monitors and so moving the mouse up from the Mac got to the Linux box fine, but moving it down from the left hand screen would not get to Windows as the program does not see it being physically there. I could live with that, except for issue two... The main issue was with the Linux screens being at the top and thus making me sit back or crank my neck upwards, not a good position. So... I got to realising that although I use both screens on the Linux…

I decided to make my own Stratum 1 NTP server for the home. No, I don’t need the accuracy, but localising stuff like that is always interesting. So, I recently purchased an Uputronics GPS HAT from Pi Hut which is marked Raspberry Pi GPS+RTC Rev 6.4. It arrived next day along with some other bits. I also got another PoE HAT and already had a Pi 4. Raspbian installed on an SD card – this time I remembered to first set it up to work via ssh – and the Pi booted ok with the GPS board flashing it’s ‘time pulse’ LED once per second. I followed instructions on the web, in particular from the two websites shown at the bottom of this post. Initial setting up of the Pi involves the use of raspi-config to stop the serial port login shell but leaving the port enabled, and disabling serial getty and bluetooth. At this point, doing cat /dev/ttyAMA0 should return data from the GPS receiver but all I got was garbled characters. More on that later. The next step was to enable PPS support which involves modifications to /boot/config.txt and a module adding to /etc/modules, plus downloading pps-tools. Running…