Projects...

So, my projects remain stalled... no idea where the time goes! I seem to be amassing bits for projects but they are just piling up. Thus far the Portsdown is still needing filters and PAs. I have a VLNA for 23cm to build. I need to move the QO100 dish from the back of the garage onto the house wall so I can mount a PA and transverter setup close enough to the shack to be able to use a transceiver, and finally get onto the wideband transverter using the Portsdown. I have dishes for higher microwave bands, a 10GHz SSPA, a 2.4GHz PA and more microwave bits coming soon including a bandpass filter for 23cm and some microwave relays. Now the weather is improving hopefully I can make some progress. I need to get a mobile tower so I can do various pointing around the house (surprisingly I am actually qualified to build these things!) which will make it easier to move the QO100 dish as well as finally getting some antennas outside. But house DIY comes first, all else is secondary... Check back this time in, umm, maybe 2025!

I seem to be collecting projects but making no progress on any of them! Well, ok I have five on the go, of which one is started and one nearly, and three are in boxes still. Since Es’Hail-2 (QO-100) went up I've been planning to set up a receiver for it, and later on hopefully a transmitter as well. One thing at a time (or in my case it seems no things at any time!) So, I have an acceptable LNB, not a good one but should suffice until I get a more decent one. I now have a bias tee, some relevant connectors, I have a roll of CT125 satellite cable somewhere and I am now waiting for a 120cm satellite dish and pole to arrive. If this arrives today I may even get it working by tomorrow, otherwise next week. The Creed 444 is the one project that has at least had some progress. For that, I now just need to wire up the 50-way D connector to the signalling unit and then it should type to itself, otherwise it will need adjusting as that's all that is left if the text is still garbled. Then there is…