Radio, railways, stuff...

M0RVB

QSL card

Up until now I've used generic QSL cards rather than an actual design. These served well as an M6 and a 2E but I always planned to design a card once I passed the full exam. So, one year on (no sense in rushing!) here it is: The basic design was done by one of my boys with the final layout and production carried out by fdsQSL who also produced my previous generic cards. The photo is my own, the logo as explained previously was basically why I chose RVB because the Morse fits the wheels. The rear has all the usual stuff including an area for 'Via' above the target callsign, both top right to hopefully make it easy for the bureau. I have only just got these and have yet to try one in the laser printer - which would make filling the details in easier. But given I hardly send any cards that is a lot of faff when a pen does just as well!

Continue reading...
M0RVB

December ISS SSTV

I only managed one almost decent image from the 1st December ISS SSTV event, the others being partial or very noisy. I am not bothering with the diplomas this time. When I checked most of them use a Google form that required me to log in (twice in one case), failed to submit and, in one case set 40 (!) cookies for the trouble.

Continue reading...
M0RVB

Portsdown / Langstone progress

Slowly coming together. Yesterday I decided to attack the front panel with a drill and mount the rotary encoder, switches and the little Arduino board which I programmed earlier. This is for tuning the Langstone. For some reason my drill press insists on making triangular holes - if I wanted a triangular hole I'd never manage of course. So I've resorted to making a smaller hole and using a round file. Anyway, everything went into place, although the Arduino board has no mounting holes so I've tie-wrapped a piece of plastic under it as an insulator and used a decent (hopefully!) sticky pad to secure the board inside the front panel. So far, so good. Here it is receiving the Allstar microHub... I need to sort the microphone out. The USB audio dongles seem to be constructed for stereo input so I wired the same to the front panel. Plugging the headset in gives no audio, presumably its all shorting out. I can make it work by 'adjusting' the plug (pulling it out until it works!) so I need to re-wire or make a little adapter. There are a couple of fans in the case and so far it seems to be keeping nice and cool. Next steps include making the GPIO breakout board and possibly the band switching stuff. Edit: of course I have a mono to stereo adapter plug, I just never looked in the junk box! Mic input now working fine...

Continue reading...