Radio, railways, stuff...

M0RVB

Printing blues

Recently our ageing HP 1022 printer has been misleading paper. There is a solenoid on the righthand side which controls the feed and the associated spring gets weak. I have stretched it three times so far, each time curing the issue for a while. A new spring is needed and, of course although I have a number of these they are all safely stored in the workshop never to be found! Coupled to the desire to print in colour and on reasonably thick paper - I'm thinking short ranges of 'special' QSL cards here - after a bit of research I chose a Xerox printer. Reasonable cost and - although as is typical with these things new toner costs more than the printer - aftermarket toner is affordable. The printer duly arrived and I set up the networking and it tried a test print. This failed to eject all the way and the printer announced it had a paper jam. Ok... try again. Nope. If I eased the sheet out as it was printing all was fine, but it never managed by itself. I did the usual things. Swearing at the printer failed to cure the issue as I had hoped. DuckDuckGo'ing for answers threw up other people with the same issue but none of their cures worked for me. But it's now, so off to the supplier who helpfully told me the contact number for Xerox. I had already registered the printer via Xerox's own mechanism so all would be fine. Nope. After being cut off the first time I spoke to someone who said that although they could see that I had registered the printer their internal systems did not realise and I could not be connected to technical support. I needed to send a proof of purchase, which I did. Some hours later I had a reply that they cannot work with said proof and needed a sales invoice. But it's a private sale - I mean, who these days buys something via the web using PayPal and expects a sales invoice? You get a receipt for payment, then a message about what you are buying, a despatch note etc. I've not seen a sales invoice since I retired. Anyway, I sent everything I had and have yet to receive a reply that I am allowed to contact their technical people about their printer which arrived faulty. Meanwhile I found the fix on the web using more flowery search terms and the printer now works fine. Good grief.

Continue reading...
M0RVB

Q secondary locator

As I have a NOV that allows the use of Q as a regional secondary locator I actually had an SSB QSO on 40m today - first time using the Q and first time on SSB voice for some time now, for over a year it's all been FT8. Excellent signal reports both ways (I had wound the wick up to 50W). I really must start talking to people again!

Continue reading...
M0RVB

70cms fail...

Seeing there is a 70cm FT8 competition on tonight I sort of threw kit together to see if it even worked. So, one big wheel ('big' on 70cms is hardly big!) and a transverter plugged together and I managed a few decodes. Good, but... It fell apart once I tried to answer a CQ. The caller was high on the waterfall and the amount of drift the blessed transverter managed after just one transmit cycle moved the received signal right off the right hand side. So that failed. I did try to answer one more station that was in the middle of the waterfall but the same happened, this time still on the waterfall but no amount of chasing it across the screen yielded a decode. Fail again. Apologies to those two stations, this transverter is clearly useless for digital modes but I thought it worth a try. A tad disappointing. I managed all of 14 miles - I think the transverter manages 10 watts. I can do 17 miles to the local 70cm repeater on a handheld and supplied short antenna on 5 watts FM.

Continue reading...