My first HF contact

Since my last post about the SG-Labs 23cm transverter I realised I have several handhelds all of which have low power settings. Time to try some FM and get a better frequency readout. 144MHz did indeed produce 1296MHz (and some small change) on the frequency counter. Time to get adventurous - GB3WC in Wakefield is about 15 miles away and pretty much line of sight and so would make a good test. With the transverter in repeater mode with a -6MHz shift (jumpers 1 and 3 on) and the FT2D programmed for 145.375MHz simplex (WC transmits on 1297.375MHz) - the transverter does the shifting - and the necessary 82.5Hz tone I can open GB3WC and receive it at S9+ on my 8 element 23cm Yagi. In the true spirit of let’s get this new shiny box working this test entailed the use of a microphone stand, some wire and some clamps. But it works. Only a quick test today as the battery was nearly out on the Yaesu and it's kind of hard to talk into it where it is. Somewhere I have a headset for it which will make life easier until I figure out how to site it…

Had my first 70MHz FT8 QSO today, and I think the third anything on 4m because there's little activity here on FM and I only just got the transverter. There was a surprising spot at -23db and 1,443km to Poland but then an actual QSO with a Welsh station at 126km. So the converted 'FM radio' dipole in the loft works, as does the transverter.

Well I got up relatively early and cut 35 foot of WF103 and soldered a PL259 on one end. The hole in the ceiling above the radios won't take the width of a plug but will - just as it turned out - take the cable. It now has one run of RG213 and three of WF103 and an RG58 and I reckon nothing else is going up that way now. My little Antex iron had no chance against the copper in the WF103 so I had to drag the reflow machine in from the workshop, overkill but it made a good joint. Got the co-linear set up and mounted and the VNA said 1.2 SWR on 2m (it only goes to 180MHz). The radio was easy to install and is smaller than I'd imagined (but then I'd not taken any notice of the stated dimensions). I put the SWR meter inline and it agreed with the 1.2 SWR on 2m and said the same for 70cm. The first thing the rig did was tell me that the micro SD card I fitted is bust so its in the bin. Another one worked fine. Mind you, I should have realised…