More on Allstar...

Been having fun with the Pluto today. It has been working fine, though not used very often with SDR Console on my acquire Windows 10 laptop but today I needed an SSB source to find a fault on the TR-9130 which had gone deaf on SSB. The Pluto made an ideal source and helped me to find out I’d got the gain and RIT controls mixed up and so had turned the gain right down! D’oh. So, after putting the TR back on the shelf it gave me the opportunity to finally fiddle with the Pluto. First off, when transmitting on SDR Console the transmission breaks at a regular short interval. Googling (well, actually these days DuckDuckGo’ing - does that work?) found some info which I tried but to no avail. Someone mentioned that it worked fine in SDR Angel so I downloaded this and after watching YouTube I managed to get a decent output. Not sure what I’ve done wrong with SDR Console but that will wait for now. But I really wanted to use the Pluto on the Linux box. Some time ago I had a go at installing the Gnu Radio software along with the modules that…

Well I fiddled with the teleprinter some more, wondering if I could at least get it to print with just 30-0-30VDC - it needs 80-0-80. Nothing. I tried connecting directly to the relevant pins for the receiving relay but could not feel any resistance when this was applied. Odd, because I could measure its resistance with a multimeter, so what's up. Strangely the next time I tried I could no longer measure the resistance. Might have been me. Then it occurred to me that on the 444 everything comes out on the 50-way D connector and you can get directly at the receiver coil, and I can see the relevant ohms. So, re-wiring the lash-up and still with 30-0-30V and with a resistor in series just in case and it burst into life. Almost. It did print, or rather tried. It got most of the letters wrong, but is at least trying. Most likely the voltage is just not quite enough, or my lash-up resistor is denying it sufficient current but I'd rather not risk the coil right now. However, and more of a concern was that although it went through the motions, the carriage did not move. It was…

...well actually aluminium. I finally cut down an old 'fm' radio dipole to 2m and quietly ran yet another run of WF103 into the loft. So the Trio TR-9130 I got a few weeks ago finally has an aerial. SWR is not bad at 1.2 or so on the VNA. It's mounted horizontally as I got the transceiver in the hope of one day finding some 2m SSB... well it's been 3 hours, nothing yet! Impatient! Anyway it worked fine for the local RSGB News this morning, and to hear someone asking if 145.5 was in use but with no callsign... This also means I finally have a use for the KW520 SWR/power meter. However, it would not register any power on the 20W setting on the 140-525MHz range but did on the 1.8-200MHz range (both of course cover 2m). I took the lid off, discovered it would be rather difficult to get at the switches to check them so put it back together. Of course it now works fine. Perhaps the initial swearing at it actually worked. The Trio causes some QRM on the speakers of one of our PCs - actually in the room below the dipole. But…