APRS fiddling

I had heard of VARA HF but not done anything about it because the Windows machine is not connected to the HF rig. That was cured yesterday by something I should have got ages ago - a USB switch. This switch has two USB connections aimed at connection to two PCs, and then four USB sockets for devices. So the SignalLink and the USB adapter for CAT control are now plugged into this switch which shares these between the Linux and Windows PCs. It all seems to work fine with USB devices connecting and disconnecting and, fortunately for Windows anyway appearing in the same place. It took me a whole to figure out that the CAT control, ends up as COM6 on the Windows box but so far it has not decided to change when reconnected. Now the Windows box can see the FT450D I tried WSJT-X - no issues there, and it provided a good end to end test. I downloaded VarAC and the VARA HF modem. Installation went fine and almost straight away it decoded a beacon on 14.105. Since then it has been decoding numerous other beacons and a few CQ calls but I have yet to…

After finding the dead LCD screen that was to be a 5.6GHz ATV receiver it also turned out that the 7" Pi screen on my Portsdown setup had similarly died - just white lines on the screen. No amount of stripping, reassembling and general fiddling fixed it. A new screen did. Anyway, I now have a Winterhill receiver. This came from a fellow ham and saved me building one. As is usual with any new box one absolutely must try it right away, which is how I discovered the bust screen on the Portsdown. After that was replaced I successfully sent a test card 40 inches across the desk! Small steps... and at least the Winterhill is in a nice box unlike my Portsdown which is still waiting for a suitably sized case - why is it all the nice metal boxes are a few mm lower than the 7" display needs. Huh.

I’ve been investigating putting some antennas outside and not getting very far. So I got a 2m ‘big wheel’ antenna off a trader on eBay. Plan A was to build my own but, being lazy I purchased a Wimo one. I’ve just installed this in the loft, directly above the shack so no issues of distancing (!) and it is a lot bigger than I had pictured. I now need to crawl under the thing to get to the fan dipole and other less important things such as the plumbing feeding the shower… hmmm. Anyway, it all went together without much struggle and the NanoVNA shows a decent low SWR across the 2m band. I’ve had to rearrange stuff so the 4m dipole is now where the 2m one was and had to be rotated 90 degrees so is now roughly north-south. Initial PSK Reporter results from the big wheel - note both the 2 and 4m antennas are fed from transverters from the transverter store in the Ukraine - showed 2m FT8 results of -14db into Cornwall and -10db into Cork plus a decent spread, and 4m picked up in south Wales so no worse than before. Of course,…