10MHz OXCO
I recently acquired a 10Ghz / 144MHz transverter which should get me a little closer to the band. I do still have a kit to build but having this means I can eventually test that as well. It needs a 10MHz reference input and I was recommended one from an eBay seller in China. The unit arrived today and having had it sat on a 'scope and counter for several hours it does seem to produce a solid 10Mhz signal at a nice sine wave (it has TTL output too). Not bad for £12.

You should also read:
Another 10MHz source
I seem to be gathering 10MHz stuff for some reason - but there is a plan. The latest toy to arrive is this BG7TBL 10MHz / 1pps GPSDO which arrived very quickly from China via Aliexpress. The primary role for this will be to feed the 10MHz distribution amplifier which in turn drives a few bits of equipment, plus give a 1pps signal to the rubidium oscillator (just for fun really!). My previous 10MHz source was the DX Patrol GPSDO which has been retired. Now I need to arrange all this frequency stuff somewhere rather than it being spread about. It's a pity this and the distribution amplifier need a maximum of 12.9V so the make shack PSUs are out and I set up a 12V SMPSU (which seems RF quiet fortunately) specifically for these plus the 12V for the Winterhill box.
Continue reading...10MHz++
I finally got myself one of the BG7TBL 10MHz distribution amplifiers. I (will) have a few devices that need a 10MHz input for frequency stability so this is handy. It actually came from China via Aliexpress a lot cheaper than similar (and rare) offerings on eBay, and it only took 5 days. Anyway, here it is: The 10MHz source is coming from the DX Patrol GPSDO and as a test one output is to a 'scope and one to a counter. Rather unexpectedly (to me) it takes a square wave feed from the DX Patrol but gives out 8 separate sinewaves. Of note, the voltage input is specified as 11.7 to 12.9V, not the usual 13.8V. But as I need 12V for the Winterhill and the 13cm transverter I already have 12V around the place. Although this one says it has an OXCO this one does not - it is an option but I decided against it. I have a decent 10MHz OXCO if I ever need it.
Continue reading...A new clock plus 10MHz reference GPSDO
I built a thing! This is a GPSDO using a PCB and kit of parts supplied by G8CUL and a OXCO from G1OGY. It uses a Jupiter GPS module which provides the PPS signal and a 10kHz output and the completed module provides 2x 10MHz and 1x 1MHz outputs. Although there are a number of such designs this one is nice in that it also has a display and shows the current date and time as UTC. This was, I think my third SMD construction and certainly the Mose SMD devices including multi-legged chips. No issues in construction especially given the quality of the PCB that G8CUL had made. The backup battery is a CR2 3.3V type and helps with warm starting. As the regulator gets hot I managed to fit a heatsink between it and the rear of the case and hopefully this will sort out heat transfer, otherwise I may need to bolt another heatsink on the rear. Construction in a die cast box would have been better maybe but the blue/white box fits in with others in the shack, plus I had it already! The bezel is cut down from a 3D printed one from Printables.com designed specifically for the 2x16 LCD displays. The button - which is not the best but I had one etc. - selects the various displays which include date and time, satellites seen, latitude, longitude, altitude and QRA locator.
Continue reading...